Let's get Bustle and Smartpay talking!
Before we start here's some things to note
With Smartpay, depending on your terminal, you can be set up with Smartlink or SmartConnect. If you are using SmartConnect - this article is not the one. Head on over here.
What Terminals can be setup with Bustle?
Smartlink integration is available with:
Smartpay D210 (mobile Wifi)
Smartpay S80 + S300 (hardwired counter-top)
Smartpay S800+ S300 (hardwired counter-top)
Smartpay S800(hardwired counter-top)
Smartpay S920 (In Wifi mode only - may show an error in Bustle when setting up but ignore error and test it works)
Once you integrate the device with the Bustle till app, it is locked down so that every Eftpos transaction must go through Bustle. You cannot use it separately.
Will I need to make changes to my router or network?
We highly recommend having a dedicated network, solely for Bustle and Smartpay if you are setting up integrated eftpos. Other devices joining the network can cause communication issues.
Getting Set Up
Set up the terminal with Smartpay
Once you receive the terminal give Smartpay a call and ask them:
to get you set up with Smartlink
for the terminal to have a Static IP
to show you how to find the IP address
Set up Bustle for eftpos
Select your provider in Setup > iPad Setup on your Bustle Hub.
Here you will see the Eftpos Integration selector Click inside the button where it says None then select your provider.
Click Save then make sure you press sync menu in Bustle app on your iPad as detailed below...
NEXT STEPS:
In the Bustle till app go to: Settings > Press Sync Menu.
After syncing is finished, fully close and restart the Bustle till app (press the iPad’s home button twice, and swipe up on Bustle to close).
Open the Bustle till app again then: Settings > Eftpos > Connect
Locate the IP address from your Eftpos terminal and enter the IP address of the Eftpos terminal into the field at the top called Smartpay Terminal IP Address, replacing the default text.
Test by pressing Logon. The terminal will run its test and should then print out a success message. (Please note: As mentioned above, the s920 terminal will show an error on the setup page but should work fine in "live" mode.)
