Let's get Bustle and Smartpay talking!
Before we start here's some things to note
With Smartpay, depending on your terminal, you can be set up with Smartlink or SmartConnect. If you are using Smartlink - this article is not the one for you. Head on over here.
SmartConnect
What Terminals can be setup with Bustle?
SmartConnect integration is available with:
Smartpay S920 mobile Wifi/GPRS (can be run on either)
Smartpay S800 fixed IP
Smartpay S80/S300 Fixed IP
Smartpay S800/S300 Fixed IP
Smartpay D210 mobile Wifi
Smartpay S90 mobile GPRS
Smartpay S900 (no longer sold)
SmartConnect has integrated tipping and surcharge - where any tip or surcharge totals from the terminal are recorded in your cash up. Contact Smartpay to get this enabled.
Getting Set Up
Set up the terminal with Smartpay
Once you receive the terminal, follow the SmartConnect guide to get set up and locate your 8 Digit Pairing Code.
(Contact Smartpay if you get stuck here)
Set up Bustle for eftpos
Select your provider in Setup > iPad Setup on your Bustle Hub.
Here you will see the Eftpos Integration selector Click inside the button where it says None, then select your provider.
Click Save then make sure you press sync menu in Bustle app on your iPad as detailed below...
NEXT STEPS:
In the Bustle till app go to: Settings > Press Sync Menu.
After syncing is finished, fully close and restart the Bustle till app (press the iPad’s home button twice, and swipe up on Bustle to close).
Open the Bustle till app again then: Settings > Eftpos > Connect
Locate your 8 digit pairing code and enter into the Connect to Smartpay Terminal window. Then press Pair Terminal
You're done!
Troubleshooting:
Can't see the SmartConnect logo in Bustle eftpos settings? If you were previously on Smartpay Smartlink you will need to press the settings button at the top right of the window, then press disconnect.